|
12.
References
Any work of others if used in the
text, it should be acknowledged. If
the numbers of authors are more than
2, then the first author’s name
followed by et al is used. Some
examples of the citation is as
follows.
-
………small fields tending to have
low accuracies even when the
effect of mixed pixels was
eliminated (Dadhwal, et
al.,1991)
-
Kanfman and Fraser (1983) has
given a qualitative explanation
for adjacency effect.
Title
REFERENCE shall be typed font
14, capital bold centered on page.
The listing should be made a space
below in the alphabetical order. If
a number of publications of the same
author (s) are referred they will be
placed in the chronological order.
Typical example is given in
Appendix 4
The organization of the thesis is
schematically shown in
Appendix 5
13.
General Instructions
1. Paper Standard A4 size (8
˝ " * 11") white, only shall be
used.
2. Font:
Type,
size and line spacing
Aerial or Times New Roman may be
used but consistently the same type
should be used throughout. Font size
12 shall be used for the text, while
titles (ABSTRACT, CHAPTER,
APPENDIX etc.) shall be bold of
size 14. The text of the thesis
shall be double spaced including
between paragraphs.
3. Margin:
Left margins must be 1.5" (38mm).
Top, right and bottom margins must
be 1" (25mm). However for all major
titles (Abstract, Chapter, etc.)
they start 2" from top page. Table
and figures also should confirm to
the above margin specifications.
After headings and subheadings the
text should start at least two full
lines gap below them. At the end of
a page if only one line of text fits
below a heading, move the heading to
the next page.
4. Page Numbers
Preliminary pages are numbered with
lower case of Roman numerals (i, ii,
iii, iv….). The title page is
numbered as (i), but this is not
typed. Similarly, declaration and
acknowledgement pages also do not
carry numbers, though they are
counted. The first page on which
number is typed will be abstract.
Pages of main text, starting with
chapter-1, should be consecutively
numbered using Arabic numerals
(1,2,3….), beginning with 1 on
chapter 1, page. Place page numbers
in the upper right hand corner 12mm
from the top edge and with last
digit even with right hand margin.
5. Tables & figures
Each table and figure must have a
unique number and title. Figures and
tables should be numbered
consecutively for each chapter. For
example if a figure is chapter 2, is
3rd then assign 2.3 to the figure.
Similar conventions applies to table
also. Figure and table captions
should be below the figure/Table and
left justified. If figures/Tables
appear in Appendices, then it shall
be represented with a prefix A. for
example Table 2 in Appendix 3 will
be designated Table A3.2
6. Equations
Like figures and tables, equations
should also be numbered
consecutively for each chapter and
represented in parenthesis at right
margin. |
